Hi Patrick, I suspect you are running in atomic mode (i.e. fast-forward mode). For the CommMonitor to actually capture any stats you need to run in timing mode (performance-modelling mode).
In Syscall Emulation mode the separate TLB module is not used afaik. Andreas On 10/14/14, 8:51 PM, "Patrick L. via gem5-users" <[email protected]> wrote: >Patrick L. via gem5-users <gem5-users <at> gem5.org> writes: > >> >> I am using a CommMonitor to log all accesses to the L1. I wrote a >>simple >> program that mallocs some space and reads and writes to it. The program >> also prints out the address returned by the call to malloc. However, in >> looking at the log of L1 accesses, I don't see that address. Does >>anyone >> know why this might be getting left out? I am running in System Call >> Emulation mode. >> > >I see that the CommMonitor logs physical addresses. However, I also see >in >my simulation output that there are no TLB accesses taking place. I am >guessing that perhaps gem5 is doing address translation somewhere besides >the TLB. Is there a simple way to get a log of what address translations >are taking place? > >Thanks and Regards, >Patrick > > >_______________________________________________ >gem5-users mailing list >[email protected] >http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users > -- IMPORTANT NOTICE: The contents of this email and any attachments are confidential and may also be privileged. If you are not the intended recipient, please notify the sender immediately and do not disclose the contents to any other person, use it for any purpose, or store or copy the information in any medium. Thank you. ARM Limited, Registered office 110 Fulbourn Road, Cambridge CB1 9NJ, Registered in England & Wales, Company No: 2557590 ARM Holdings plc, Registered office 110 Fulbourn Road, Cambridge CB1 9NJ, Registered in England & Wales, Company No: 2548782 _______________________________________________ gem5-users mailing list [email protected] http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
