Hello, do you run SPEC with 1 or more threads?
Best regards, Jasmin On Fri, Dec 15, 2017 at 4:57 PM, Mohammad Khasawneh <mkhas...@binghamton.edu > wrote: > Hello, > > > > I’m trying to get SPEC2017 to run in SE mode (X86) as SPEC2006 did, so far > the only benchmark that ran to completion is 505.mcf_r with no > modifications to the basic config file. Here is what I did: > > > > 1. Compiled benchmarks statically (although it seems this is no longer > a requirement on newer gem5 versions). > 2. Made sure binaries execute natively on host. > 3. Ran them through gem5 pretty much like I used to run SPEC2006. > > > > What I get: > > On many of them a common error I get is this: > > > > panic: Unrecognized/invalid instruction executed: > > > > { > > leg = 0x10, > > rex = 0, > > vex/xop = 0x5, > > op = { > > type = three byte 0f3a, > > op = 0x18, > > }, > > modRM = 0, > > sib = 0, > > immediate = 0, > > displacement = 0 > > dispSize = 0 > > } > > > > I’m assuming a change in the config file would force the compiler to > produce more sensible binaries, any ideas on where I should start digging > would be appreciated. > > > > Thank you, > > Mohammad > > _______________________________________________ > gem5-users mailing list > gem5-users@gem5.org > http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users >
_______________________________________________ gem5-users mailing list gem5-users@gem5.org http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users