Hi Brian,

Thanks for the comments. Please see below prefixed by <RA>:

1. 6. Session Establishment

   A BFD session is boot-strapped using LSP-Ping. This specification
   describes procedures only for BFD asynchronous mode.

Should you state explicitly that BFD Demand mode MUST NOT be used?

<RA> I will spell out that BFD demand mode is out of scope.

7. Encapsulation

   ...

   The BFD control packet sent by the ingress LSR MUST be a UDP packet
   with a well known destination port 3784 [BFD-IP] and a source port
   assigned by the sender as per the procedures in [BFD-IP]. The source
   IP address is a routable address of the sender. The destination IP
   address is randomly chosen from the 127/8 range,

This is written in IPv4 terms. What happens in an IPv6-only environment?
There is no range of loopback addresses to borrow in IPv6, but you could
use a ULA prefix.

<RA> The procedures of RFC 4379 need to be used which is
basically a destination IPv6 address from the range
0:0:0:0:0:FFFF:127/104. I will spell this out. Thanks for the catch.

Will fix the idnits.

Thanks,
rahul



On Thu, 1 May 2008, Brian E Carpenter wrote:

>
>
>
>
>
_______________________________________________
Gen-art mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/gen-art

Reply via email to