Hi Gurbeer,
xdmp:document-insert is a low-level function, that will certainly be necessary, but you might be better off using a more off-the-shelf solution like recordloader, xqsync, or perhaps even the built-in information studio. The latter would require writing a custom collector, that reads from a source database, and creates transactions for them, but the ingestion would otherwise be taken care off, all within MarkLogic. Kind regards, Geert *Van:* [email protected] [mailto: [email protected]] *Namens *Singh, Gurbeer *Verzonden:* maandag 11 februari 2013 22:18 *Aan:* [email protected] *Onderwerp:* [MarkLogic Dev General] How to move content from one data base to another Hi, We have created two Database under a ML instance. Now we have to move some content from one data base to another , before moving we need to do apply some logic. I was wondering how can use xdmp:document-insert for this approach. ~Gurbeer ------------------------------ NOTICE: Morgan Stanley is not acting as a municipal advisor and the opinions or views contained herein are not intended to be, and do not constitute, advice within the meaning of Section 975 of the Dodd-Frank Wall Street Reform and Consumer Protection Act. If you have received this communication in error, please destroy all electronic and paper copies and notify the sender immediately. Mistransmission is not intended to waive confidentiality or privilege. Morgan Stanley reserves the right, to the extent permitted under applicable law, to monitor electronic communications. This message is subject to terms available at the following link: http://www.morganstanley.com/disclaimers If you cannot access these links, please notify us by reply message and we will send the contents to you. By messaging with Morgan Stanley you consent to the foregoing.
_______________________________________________ General mailing list [email protected] http://developer.marklogic.com/mailman/listinfo/general
