Hi Egor, On Wed, 2007-04-11 at 19:09, Egor Tur wrote: > Hi folk. > > I see that my small problem has been interesting.
Glad you've been entertained :-) > Thanks for your help. > > > > Rate 6 is 20 Gb/sec whereas 3 is 10 Gb/sec. So the port is 4x DDR (rate > > > 6) and the group is 4x SDR. The request is for equal to the rate so it > > > fails. > > > > > > Are all your ports DDR or do you have a mix ? If all are DDR, you can > > > configure the default partition to use this rate. > > > > To elaborate a little more on this, the configuration would be done via > > /etc/osm-partitions.conf file with a single line as follows: > > > > Default=0x7fff,ipoib,rate=6:ALL=full; > > > > I have identical DDR HCA and DDR switch. > I configured the default partition with the same rate. > The problem has been solved. Great. That's a good data point. You are using OFED 1,2. Can you sttate which distro/kernel you are using and which arch ? Thanks. -- Hal > > > > > > > > If modules was builded with --without-ipoib-cm then ib_ipoib don't > > > > depend on ipv6. > > > > But the messages remain the same in log. > > > > Are you using IPoIB (for IPv4) ? If so, is that working ? > > > > -- Hal > > Yes I use IPoIB and I think that is working. > At least the tests, benchmarks and our parallel tasks is working. > > Thanx. > > > _______________________________________________ > general mailing list > [EMAIL PROTECTED] > http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general > > To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general _______________________________________________ general mailing list [EMAIL PROTECTED] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
