On Wednesday 18 April 2007 23:42:16 Robert Walsh wrote: > Bernd Schubert wrote: > > Hi, > > > > from time to time I see these messages in the logs > > > > [14052.195559] ib_ipath 0000:0a:00.0: infinipath0: invalidaddr error > > > > What does that mean? Can it cause further problems? > > That depends. This means something wrote to a bogus address on the > chip. This won't cause further problems. However, that write was > ignored, so something may not have happened that should have happened. > > This could be a driver bug, or a bug in a layer above it. If you're > concerned about this, I'd suggest contact our support organization > ([EMAIL PROTECTED]) and asking them for help. Give them some details > on your environment (what hardware and software you're using) and what > you were doing at the time and they should be able to help you narrow > down the problem.
Thanks, going to report this. As usual I'm running lustre stress tests and with ipath cards I'm able to triggre a known bug in lustre, which occurs very rarely without ipath cards. The error message above is from the point of time not very closely related and happens also much less often than the lustre bug, but at least its a message from the ipath controller... . Thanks again, Bernd PS: https://bugzilla.lustre.org/show_bug.cgi?id=11544 -- Bernd Schubert Q-Leap Networks GmbH _______________________________________________ general mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
