Mellanox experts:
I'm having problems with one of my ConnectX cards. When I load
mlx4_core, it logs the following error.
Any suggestions on how to proceed?
Steve
-------
mlx4_core: Mellanox ConnectX core driver v0.01 (May 1, 2007)
mlx4_core: Initializing 0000:0c:00.0
mlx4_core 0000:0c:00.0: PCI INT A -> GSI 33 (level, low) -> IRQ 33
mlx4_core 0000:0c:00.0: setting latency timer to 64
mlx4_core 0000:0c:00.0: RUN_FW command failed, aborting.
mlx4_core 0000:0c:00.0: Failed to start FW, aborting.
mlx4_core 0000:0c:00.0: PCI INT A disabled
mlx4_core: probe of 0000:0c:00.0 failed with error -22
------
Here is the lspci info:
0c:00.0 InfiniBand: Mellanox Technologies Unknown device 673c (rev a0)
Subsystem: Mellanox Technologies Unknown device 673c
Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 33
Region 0: Memory at ef300000 (64-bit, non-prefetchable) [size=1M]
Region 2: Memory at e0000000 (64-bit, prefetchable) [size=8M]
Capabilities: [40] Power Management version 3
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [48] Vital Product Data
Capabilities: [9c] MSI-X: Enable- Mask- TabSize=256
Vector table: BAR=0 offset=0007c000
PBA: BAR=0 offset=0007d000
Capabilities: [60] Express Endpoint IRQ 0
Device: Supported: MaxPayload 256 bytes, PhantFunc 0, ExtTag+
Device: Latency L0s <64ns, L1 unlimited
Device: AtnBtn- AtnInd- PwrInd-
Device: Errors: Correctable- Non-Fatal- Fatal+ Unsupported-
Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop-
Device: MaxPayload 256 bytes, MaxReadReq 512 bytes
Link: Supported Speed unknown, Width x8, ASPM L0s, Port 8
Link: Latency L0s unlimited, L1 unlimited
Link: ASPM Disabled RCB 64 bytes CommClk- ExtSynch-
Link: Speed 2.5Gb/s, Width x4
Capabilities: [100] Unknown (14)
_______________________________________________
general mailing list
[email protected]
http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general
To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
