Hi Nicolas,
I tried with "ibportstate <switch lid> <switch port#> reset" but I got the
following error:
ibwarn: [19660] mad_rpc: _do_madrpc failed; dport (Lid 7)
ibportstate: iberror: failed: smp set portinfo failed
Have you ever run it successfully on Qlogic 9024 switch?
Thanks!
Yicheng Jia
Nicolas Morey-Chaisemartin <[email protected]>
04/03/2009 12:05 PM
Please respond to
[email protected]
To
Yicheng Jia <[email protected]>
cc
[email protected]
Subject
Re: [ofa-general] change port's physical state without reset HCA
No you just need to do one or the other.
It's not necessaray to do both.
Nicolas
Yicheng Jia a écrit :
>
> Hi Nicolas,
>
> Do I need to restart HCA driver if I just use ibportstate to reset the
> cable on the switch side?
>
> Thanks!
>
> Yicheng Jia
>
>
>
>
> *Nicolas Morey-Chaisemartin <[email protected]>*
>
> 04/03/2009 11:47 AM
> Please respond to
> [email protected]
>
>
_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs.
For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________
_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs. For
more information please visit http://www.ers.ibm.com
_____________________________________________________________________________
_______________________________________________
general mailing list
[email protected]
http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general
To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
