Hi Jason,
a few things you could try to determine who the manufacturer is:
- 'mstflint -d 07:00.0 q' will give you some info, especially the HCA GUIDs.
The 24 most significant bits of the board GUIDs gives you the manufacturer.
For example:
- 0002c9 Mellanox
- 0008f1 Voltaire
- try to run 'mstflint -d 07:00.0 dc'. The PS_INFO, ADAPTER and IB sections
could give some more hints.
Hope this helps.
Sebastien.
On Tue, 2 Jun 2009 21:03:13 -0400
Jason Hill <hil...@ornl.gov> wrote:
> All,
>
> Being somewhat cautious I'd like to see if anyone can point me at the correct
> manufacturer info for an Infiniband card that we bought through a cluster
> vendor
> (i.e. it was in the box when we got it). I need to upgrade the firmware to
> attempt to isolate an issue we're seeing with several nodes that have this
> combination:
>
> ==> /sys/class/infiniband/mthca0/board_id <==
> INT0020000001
>
> ==> /sys/class/infiniband/mthca0/fw_ver <==
> 1.1.0
>
> ==> /sys/class/infiniband/mthca0/hw_rev <==
> a0
>
> ==> /sys/class/infiniband/mthca0/hca_type <==
> MT25204
>
> ~$ lspci -vvv
> <snip>
>
> 07:00.0 InfiniBand: Mellanox Technologies MT25204 [InfiniHost III Lx HCA]
> (rev 20)
> Subsystem: Mellanox Technologies MT25204 [InfiniHost III Lx HCA]
> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
> Stepping- SERR+ FastB2B-
> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Latency: 0, Cache Line Size: 64 bytes
> Interrupt: pin A routed to IRQ 50
> Region 0: Memory at feb00000 (64-bit, non-prefetchable) [size=1M]
> Region 2: Memory at fd800000 (64-bit, prefetchable) [size=8M]
> Capabilities: <access denied>
>
> On the card itself it has :
>
> Part Number: D83914
> Serial Number: MEPT702000093
> And the card has a tall bracket, but the vendor could have swapped that.
>
> Google has turned up nothing for the Board ID and part number/serial number.
>
> To me it looks kind of like a Cisco card, so I was thinking it might be a
> Topspin. We bought the cluster in 2007.
>
> Would the right thing be to install the MemFree MHGS18-XT firmware, or try a
> revision of the MHGS18-XTC?
>
> Thanks for the time and thoughts.
>
_______________________________________________
general mailing list
general@lists.openfabrics.org
http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general
To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
