Hello,

I have downloaded, built, and begun testing Sculpt EA, following the instructions linked to in the 18.02 release notes. Everything went well during the build process.

Since I primarily run everything I do in VirtualBox (and don't have the recommended hardware anyway), I created a VM as close to the recommendations as possible. It booted fine from a virtual CD, the system came up using the VESA framebuffer driver, the mouse worked, and I was able to follow the instructions until I got to the part about storage. Unfortunately, there are no "<device>" nodes under "<block_devices>" in "/report/drivers/block_devices".

I have the VM set up with a "SATA" controller and a single virtual drive. Has anyone tried this? Do you have any hints on how to diagnose what is going wrong?

Also, I modified the config to use wired networking (using a virtual Intel-based NIC), but I couldn't think of a way to easily test whether it is working or not. (I'm sure I'm missing something obvious here, but I appreciate any hints.)

If I can get those two items working, it looks like I'll be in good shape!

 Thanks,
--
  John J. Karcher
  devu...@alternateapproach.com

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
genode-main mailing list
genode-main@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/genode-main

Reply via email to