How To UnSubscribe

   First, send me $29.95 + 6.95 shipping for an Unsubscribing Kit.
When you receive it, follow these directions.

   The basic kit will be the standard no-fault type. Depending on
your specific requirements, System A and/or System B can be used. When
operating System A, depress yellow lever and a plastic dalkron
unsubscriber will be dispensed through the slot immediately
underneath. When you have fastened the adhesive lip, attach connection
marked by the large "X" on the outlet hose. Twist the silver-coloured
ring one inch below the connection point until you feel it lock into
position.

   The kit is now ready for use. The Cin-Eliminator is activated by
the small switch on the lip. When securing, twist the ring back to its
initial condition, so that the two orange lines meet. Disconnect.
Place the dalkron unsubscriber in the vacuum receptacle to the rear.
Activate by pressing the blue button.

   The controls for System B are located on the opposite side. The
red release switch swings the Cin-Eliminator into position; it can be
adjusted manually up or down by pressing the blue manual release
button. The opening is self-adjusting. To secure after use, press the
green button, which simultaneously activates the evaporator and
returns the Cin-Eliminator to its neutral position.

   You may log off if the green exit light is on over the evaporator.
If the red light is illuminated, one of the Cin-Eliminator
requirements has not been properly implemented. Press the "List Guy"
call button, located to the right of the evaporator. He will secure
all facilities from his control panel.

   To use the Auto-Unsub, first undress and place your clothes in the
clothes rack. Put on the Velcro slippers located in the cabinet
immediately below. Enter the shower, taking the entire kit with you.
On the control panel to your upper right upon entering you will see a
"Shower seal" button. Press to activate. A green light will then be
illuminated immediately beneath the button. On the intensity knob,
select the desired setting. Now depress the Auto-Unsub activation
lever and bathe normally.

   The Auto-Unsub will automatically turn off after three minutes
unless you activate the "Manual off" override switch by flipping it
up. When you are ready to leave, press the blue "Shower seal release"
button. The door will open and you may leave. Please remove the Velcro
slippers and place them in the receptacle provided.

   If you prefer the ultrasonic log-off mode, press the indicated
orange button. When the twin panels open, pull forward by rings A & B.
The knob to the left, just below the blue light, has three settings,
low, medium or high. For normal use, the medium setting is suggested.

   After these settings have been made, you can activate the device
by switching to the "ON" position the clearly marked red switch. If
during the unsubscribing operation, you wish to change the settings,
turn the "manual off" override switch to the "OFF" position. You may
now make the change and repeat the cycle. When the green exit light
goes on, you may log off and have lunch. Please close the door behind
you to avoid discharging the Cin-Eliminator during periods of nonuse.

2006/12/8, roberts <[EMAIL PROTECTED]>:
unsubscribe

--
[email protected] mailing list




--
[]s
Joaquim
------------------------------------------
 (o_    Joaquim Quinteiro Uchoa
//\        Consultor Linux e EaD
U_/_    Linux User # 100534
------------------------------------------
--
[email protected] mailing list

Reply via email to