Are you using two different cards? Mine is just the ATI FireGL. I've set up
a separate devcice section, but am having trouble figuring out which PCI Bus
to assign it to:
$cat /proc/pci :
.
.
.
Bus 1, device 0, function 0:
VGA compatible controller: ATI Technologies Inc M10 NT [FireGL Mobility
T2] (rev 128).
IRQ 11.
Master Capable. Latency=255. Min Gnt=8.
Prefetchable 32 bit memory at 0xe0000000 [0xe7ffffff].
I/O at 0x3000 [0x30ff].
Non-prefetchable 32 bit memory at 0xc0100000 [0xc010ffff].
Bus 2, device 0, function 0:
CardBus bridge: Texas Instruments PCI4520 PC card Cardbus Controller (rev
1).
IRQ 11.
Master Capable. Latency=168. Min Gnt=192.Max Lat=5.
Non-prefetchable 32 bit memory at 0xb0000000 [0xb0000fff].
Bus 2, device 0, function 1:
CardBus bridge: Texas Instruments PCI4520 PC card Cardbus Controller (#2)
(rev 1).
The first one is the main controller, and in my main Device section I have:
BusID "PCI:1:0:0"
Screen 0
I've set up a second Device section, which points at Screen 1, I've assigned
BusID 2:0:0 and 2:0:1, and I get this message:
(WW) fglrx: No matching Device section for instance (BusID PCI:1:0:0) found
(EE) No devices detected.
Thoughts?
Thanks,
Steve
On Wednesday 04 May 2005 14:47, Ciaran McCreesh typed:
:: On Wed, 4 May 2005 14:31:38 -0500 steve fox <[EMAIL PROTECTED]> wrote:
:: | So you have a separate device section in which you have a different
:: | BusID. Do you also have a separate Screen section, and do you refer
:: | to it in ServerLayout?
::
:: Yup. I have a screen for the onboard LCD and a screen for the external
:: port. Said screens point to different device definitions. Then I switch
:: the Screen option in ServerLayout as needed.
--
[email protected] mailing list
