Hi,
I don't really get the question but I'll try to help you out with logic.
Never did I install asterisk but I did build a test case with apache
and a router on the same box.
First you shall ask what you want to see on eth0 and eth1. On my test
case I wanted to see all port of apache on eth1 (lan) and only port80
on eth0 (wan).
I manage to route all network between lan & wan with simple routing
rules but I did had to build a special case where I wanted to NAT eth0
port80 request to my loopback (lo) where my local apache is listening.
I also NATed eth1 to the lo when explicitly requesting answer from
eth1's IP (more then 1 IP is handy when using chroot or other special
security need).
I guess you'll have to setup proper listening port to asterisk before.
Additionally a little bit of reading (more then some howto) could be
good as securing a router and a server on a same machine is a serious
task (note that it still a not so hard one) that request a good plan.
I had to rethink mine twice before getting the good setup. Test
machine died in a power outage since and didn't got time to build it
back so I can't supply exemple script.
Hope it did help you out.
LMA1980
Le 09-11-08 à 09:56, Tamer Higazi a écrit :
Hi people!
I am not a network pro, therefor I ask you gladly for help. I have a
gentoo box with 2 eth0 cards. I have red the gentoo home router
guide at:
http://www.gentoo.org/doc/en/home-router-howto.xml?style=printable
but I need to use the machine as router as well as server itself.
I have 2 NIC in the machine (eth0,eth1). On the machine is asterisk
and
apache installed. I want to use the machine a router and server as
well.
the sip gateway connected at eth0 is configured as:
192.168.1.5 with it's gateway 192.168.1.1 and nothing goes along to
asterisk.
I guess, it's not possible to have on the same gateway address a
service
running. Could you give me some good advise how to get the thing to
run?!
# This network configuration was written by net-setup
config_ppp0=("ppp")
link_ppp0="eth1"
plugins_ppp0=("pppoe")
pppd_ppp0=(
"defaultroute"
"usepeerdns"
)
username_ppp0="xxxx"
password_ppp0="xxxx"
config_eth1=("85.183.112.3 broadcast 85.255.255.255 netmask
255.0.0.0")
config_eth0=("192.168.1.1 broadcast 192.168.1.255 netmask
255.255.255.0")
Tamer
