Dear all,
I'm in a battle with a Promise SX4000 ATA Raid Controller.
I had install 1.4_rc3 without problem on a disk connected to the 'normal' IDE
controller. But I'm unable to use the Promise controller. I tried a lot of kernels,
without success. At boot time the kernel recognize the Promise but without the disk
array connected to it.
There is someone that use this controller under Gentoo?
Thanks
--
\\\ //
(0 0)
------------------------ooO-(_)-Ooo-------------------------------
#============================#=====================================#
| ENRICO MORELLI | email: [EMAIL PROTECTED] |
| * * * * | phone: +39 055 4574269 |
| University of Florence | fax : +39 055 4574253 |
| CERM - via Sacconi, 6 - 50019 Sesto Fiorentino (FI) - ITALY |
#============================#=====================================#
--
[EMAIL PROTECTED] mailing list
