I think you fogot to include your dmesg output.
The relevant lines from dmesg at boot time:
Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] PCI: Found IRQ 11 for device 00:0a.0 [...] Yenta IRQ list 0098, PCI irq11 Socket status: 30000827
The additional lines from dmesg after removing and the inserting the pcmcia card again:
cs: cb_alloc(bus 2): vendor 0x10ec, device 0x8139 PCI: Enabling device 02:00.0 (0000 -> 0003) 8139too Fast Ethernet driver 0.9.26 PCI: Setting latency timer of device 02:00.0 to 64 eth0: RealTek RTL8139 Fast Ethernet at 0xca06a000, 00:10:60:5b:f1:f8, IRQ 11 eth0: Identified 8139 chip type 'RTL-8139C'
> Also, did you take a look at /var/log/messages or /var/log/syslog to > see if the module for your pcmcia card was able to load?
I've compiled the driver as part of the kernel. I've also tried compiling 8139too as a module. The module does not load until i remove and insert the card again...
-- [EMAIL PROTECTED] mailing list
