I've had to specify them by their full names, as opposed to their aliases, e.g., -artwiz-nu-*-*-*-*-*-*-*-*-*-*-*-*.
On 15:58 Sun 19 Oct , Matt Garman wrote: > > I merged the development version of fluxbox (v0.9.6) via > /usr/portage/x11-wm/fluxbox/fluxbox-0.9.6_pre9.ebuild. I also installed the > package artwiz-fonts. At least xfontsel can see the artwiz fonts. However, > fluxbox is not using them. > > So I'm curious if I need to indicate the location of the artwiz-fonts in some > config file. gvim also cannot use the artwiz fonts. > > In general, is there a "Gentoo X Fonts HOWTO" or similar documentation? My > default font is a fairly small and somewhat blury sans-type font. It was used > by MozillaFirebird (until I tweaked the settings), it's used by the gkrellm > configuration screen, it's used by xchat-2, etc. So I'd like to make the > default something "prettier". > > I'm assuming there's a fairly standard set of steps that most Gentoo folks take > to setup "nice" fonts after a fresh install. Is this documented somewhere? > > Thanks, > Matt > > > > -- > [EMAIL PROTECTED] mailing list > -- Barry Marler Plant Genome Mapping Laboratory University of Georgia Room 229, Center for Applied Genetic Technologies 111 Riverbend Rd. Athens, GA 30602 706.583.0164 [office] 706.583.0160 [fax] http://www.plantgenome.uga.edu -- [EMAIL PROTECTED] mailing list
