On Sun, 27 Feb 2005 09:29:41 -0800, Manuel McLure wrote
> pat wrote:
> > Hi Heinz,
> >
> > I want to use my flash drive for USB. When I plug the drive there is not
> > response within the USB (no dmesg info). I expect hotplug to enable ust
> > after
> > the drive plug and creation of the /dev/sdaX devices.
> >
> > Could you help me ???
>
> If there are no dmesg messages when you plug the device in, it means
> it isn't getting detected by the kernel, so the hotplug message
> isn't getting sent.
>
> This sounds like a problem with your USB kernel configuration (or
> the USB port you're plugging into) rather than hotplug/coldplug.
>
> Make sure that CONFIG_USB_STORAGE is set to "y" in your kernel
> configuration.
>
Yes, the problem was in kernel configuration.
Pat
--
[email protected] mailing list
