On Wed, 2005-04-20 at 12:05 -0600, Tres Melton wrote:
> This is my lilo (grub has the same thing)
>
> append="ether=5,0xe400,eth0 ether=10,0x300,eth1"
>
> and it ensures that eth0 is the one on irq5 and eth1 on irq10
I'm trying to figure out the I/O addresses.
For one of the cards we have this, so it's obvious what the I/O address
is:
0000:00:06.0 Ethernet controller: Intel Corporation 82557/8/9 [Ethernet
Pro 100]
(rev 08)
Subsystem: Intel Corporation 82559 Fast Ethernet LAN on
Motherboard
Flags: bus master, medium devsel, latency 64, IRQ 31
Memory at feafd000 (32-bit, non-prefetchable)
I/O ports at d400 [size=64]
Memory at fe900000 (32-bit, non-prefetchable) [size=1M]
Capabilities: [dc] Power Management version 2
However for the other card, I don't see an I/O line:
0000:02:01.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5701
Gigabit
Ethernet (rev 15)
Subsystem: Compaq Computer Corporation: Unknown device 007a
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 24
Memory at febe0000 (64-bit, non-prefetchable) [size=febb0000]
Expansion ROM at 00010000 [disabled]
Capabilities: [40] PCI-X non-bridge device.
Capabilities: [48] Power Management version 2
Capabilities: [50] Vital Product Data
Capabilities: [58] Message Signalled Interrupts: 64bit+
Queue=0/3 Enable
I also tried lspci -vvv and just didn't find what I was lookin for. Any
ideas?
--
[email protected] mailing list
