On 5/11/05, Michael Haan <[EMAIL PROTECTED]> wrote: > On 5/10/05, James Colannino <[EMAIL PROTECTED]> wrote: > > Michael Haan wrote: > > > > >So I was looking at the source tree last night for my kernel 2.6.9-r14 > > >and I do see these options. I was under the impression these were > > >only available for 2.6.12, but maybe what was meant was that for > > >2.6.12 you don't even need to choose to compile them in. That said, > > >when looking at the tree for DVB, it seemed to want me to pick some > > >kind of "front end" - not sure what it wants there. Finally, it > > >appears my version of ivtv (I've got a pvr 350 as well), 2.3 I think, > > >may be conflicting with the pchdtv. Does that jive with your > > >experience? > > > > > > > > > > I don't think I compiled any of the in-kernel tuner drivers (like > > ivtv.) What I did do was compile all of the video stuff as modules. > > That way, modprobbing the drivers for your HD-3000 should automatically > > pull in only those modules you need (such as the v4l2 and dvb stuff.) > > Hope that helps :) I actually can't remember quite what I did, but if > > you need further help I can go through my kernel tree again and tell you > > what I have enabled and what I don't. > > > > James > > -- > > [email protected] mailing list > > > > > > Ok, making progress. I unmerged ivtv and installed 0.3.4j instead > from www.ivtv.tv. Now I get the following: > > >modprobe cx88-dvb > dmesg shows... > or51132: Unknown symbol release_firmware > or51132: Unknown symbol request_firmware > cx88_dvb: Unknown symbol or51132_attach > > >modprobe cx8800 > dmesg shoes.... > cx2388x v4l2 driver version 0.0.4 loaded > cx88[0]: subsystem: 7063:3000, board: pcHDTV HD3000 HDTV > [card=22,autodetected] > saa7115: starting probe for adapter cx88[0] (0x10005) > tuner: chip found at addr 0xc2 i2c-bus cx88[0] > tuner: type set to 52 (Thomson DDT 7610 (ATSC/NTSC)) by cx88[0] > tveeprom: Encountered bad packet header [04]. Corrupt or not a Hauppauge > eeprom. > cx88[0]/0: found at 0000:02:08.0, rev: 5, irq: 5, latency: 32, mmio: > 0xdc000000 > cx88[0]/0: registered device video1 [v4l2] > cx88[0]/0: registered device vbi1 > cx88[0]/0: registered device radio1 > > finallly > >modprobe cx88-dvb > dmesg still shows... > or51132: Unknown symbol release_firmware > or51132: Unknown symbol request_firmware > cx88_dvb: Unknown symbol or51132_attach > > Almost there - what's next? >
As another data point, I ran make menuconfig and enabled a few v4l and dvd options and then make && make modules_install gives: WARNING: /lib/modules/2.6.9-gentoo-r14/extra/cx25840.ko needs unknown symbol crypto_alloc_tfm WARNING: /lib/modules/2.6.9-gentoo-r14/extra/cx25840.ko needs unknown symbol crypto_free_tfm WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/bttv.ko needs unknown symbol release_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/bttv.ko needs unknown symbol request_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/dvb-bt8xx.ko needs unknown symbol request_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/cx88-atsc.ko needs unknown symbol release_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/cx88-atsc.ko needs unknown symbol request_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/sp887x.ko needs unknown symbol release_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/or51211.ko needs unknown symbol release_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/or51132.ko needs unknown symbol release_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/or51132.ko needs unknown symbol request_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/saa7134-dvb.ko needs unknown symbol request_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/cx88-blackbird.ko needs unknown symbol release_firmware WARNING: /lib/modules/2.6.9-gentoo-r14/v4l2/cx88-blackbird.ko needs unknown symbol request_firmware -- [email protected] mailing list
