if I run ifconfig -a this currently what I get.
I have completed the installtion, but Kernel Modules I am not sure about.
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.1.105 netmask 255.255.255.0 broadcast 192.168.1.255
inet6 fe80::be5f:f4ff:fee8:5914 prefixlen 64 scopeid 0x20<link>
ether bc:5f:f4:e8:59:14 txqueuelen 1000 (Ethernet)
RX packets 435 bytes 234999 (229.4 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 476 bytes 90064 (87.9 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 16436
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 0 (Local Loopback)
RX packets 4 bytes 300 (300.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 4 bytes 300 (300.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlan0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 00:0e:2e:e4:fb:cd txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
On 2/3/14, Amankwah <[email protected]> wrote:
> On Mon, Feb 03, 2014 at 02:36:29PM +0200, Stephen Reynolds wrote:
>> Hi all
>>
>>
>>
>> I am doing a new Gentoo installation and I cannot get my network cards to
>> work.
>> I have two cards
>>
>>
>>
>> 1) eth0 = Realtek RLTl8111e
>>
>> 2) wlan0 = RaLink RT2561/RT61
>>
>>
>>
>> Gen Kernel has support for both.
>>
>>
>>
>> Please advise me as to what steps I can take to fix this?
>>
>
> You should comfirm that the drivers of the adapters are compiled and
> loaded correctly. And for the wireless network, relys on you AP settings
> you may need the application like the net_wireless/wpa_supplicant.
>
>
