On Tuesday 22 Dec 2015 01:12:10 Kai Krakow wrote: > Am Tue, 22 Dec 2015 00:54:35 +0000 > > schrieb Mick <[email protected]>: > > On Tuesday 22 Dec 2015 00:48:13 Neil Bothwick wrote: > > > On Mon, 21 Dec 2015 23:55:06 +0000, Mick wrote: > > > > > Are you trying to run ifplugd from its init script? It's not > > > > > meant to be used like that with openrc. > > > > > > > > I don't have any init scripts for ifplugd. I wondered what starts > > > > it/stops it, and found /lib64/netifrc/net/ifplugd.sh > > > > > > It should be started by the net.eth* scripts, so you need to start > > > the network interface first. > > > > Thanks again Neil. I don't think this is as you suggest. I never > > had wired or wireless interfaces enabled to start at boot time, > > because ifplugd started them up as necessary. > > > > From the README file: > > The network interface which is controlled by ifplugd should not be > > configured automatically by your distribution's network subsystem, > > since ifplugd will do this for you if needed. > > But that doesn't apply here because the "net.* plugin" starts ifplugd, > and defers further initializations until ifplugd detects a link. > > This is what I meant when I talked about pushing ifplugd further down > the layer. I just didn't remember that this is now solved by a plugin > in net.* itself. > > Don't enable ifplugd service. Openrc will do its magic.
There is no means of enabling or disabling the ifplugd service that I have found, because there is no /etc/init.d/ifplugd script. Once installed ifplugd always starts at boot and daemonizes, configuring or tearing down connections as a link is detected or lost. To make it clearer, this is how it used to work on two laptops: I install ifplugd and remove from rc-update any net.<iface> that I have configured. ifplugd will always start at boot as a daemon and will bring up and configure the wired NIC once a cable is detected. There is no start up script in /etc/init.d/ installed by default, although the man page mentions it, along with /etc/ifplugd/ifplugd.conf, which is also not installed. This is the only file that installed on my systems: # find /etc -iname *ifplug* /etc/ifplugd /etc/ifplugd/ifplugd.action I started this thread because recently I have to start my wired interface manually, after which point ipfplugd also starts, daemonizes and manages the connection. This is not how it used to work - I never had to start the wired interface myself. Furthermore, starting ifplugd on a terminal now shows that it is listening on eth0 instead of enp11s0, but hadn't tried this before things broke. According to the man page eth0 is the default, but I can't recall manually specifying a different interface for ifplugd in the past. It always brought up the wired interface, no matter what it was called. -- Regards, Mick
signature.asc
Description: This is a digitally signed message part.
