Dale wrote:
Hi folks,
I recently upgraded gcc and to KDE 3.5. I have a dial-up connection
and a serial modem. I did a emerge -e system twice and a emerge -e
world during the gcc upgrade. I then upgraded KDE. Since I did this
my modem connection has been really slow. It connects at the same
speed but it has a lot of dead time. It sends a little data, then
waits a while, sends a little, waits a while etc. I am even having
trouble doing a sync because it takes so long the server kicks me
off. It does it on most all sites. It does it in Mozilla, Konqueror
when I emerge something, whatever. It also does it if I login to my
old KDE 3.4 session as well. I don't think it is KDE. It also does
it when I am downloading emails from my ISP.
I also did a kernel upgrade as well because one of the packages, I
think it was hal or dbus, needed a newer kernel. I copied my .config
over and did a make oldconfig. As far as I can tell, all my old
settings are the same. I checked it with the make menuconfig of course.
I have also tried to connect with Kppp and the pon and poff commands.
I never did get wvdial to work. It does the same with either
connection though.
I did a lot of etc-updates during the upgrade. I did make a back-up
of /etc though. What files should I check though? What could cause
this? I'm afraid that if I copy the old /etc back over some things
may break. I know one of the programs made me delete the old files
because of some major changes. Seems it was hal, dbus or ivman, can't
recall which though.
I use iptables for my other rigs to connect to the net with. I
stopped the service just to try it, not any difference.
Any ideas? Let me know if you need me to post something.
Thanks for the help.
Dale
:-)
Well, I have found out this much but I need some help figuring out the
rest. I booted into my old Gentoo and the modem works fine and it
connects the same way, the ARQ thing. It uses the old kernel, the old
hal, dbus and the old KDE. I am beginning to think this is a kernel
thing but I can't back up a version because hal, dbus or one of them
requires this kernel or higher and my new KDE requires the new hal,
dbus, sounds like a catch 22 don't it.
What can I do to make sure it is the kernel? Is it possible to back up
a kernel version, the one the old Gentoo uses, and not botch up hal,
dbus or something?
Just to make it more clear. I have to versions of Gentoo on two
seperate hard drives. I redone my install when I moved to a faster drive.
Thanks
Dale
:-)
--
To err is human, I'm most certainly human.
I have four rigs:
1: Home built; Abit NF7 ver 2.0 w/ AMD 2500+ CPU, 1GB of ram and right now two
80GB hard drives.
2: Home built; Iwill KK266-R w/ AMD 1GHz CPU, 256MBs of ram and a 4GB drive.
3: Home built; Gigabyte GA-71XE4 w/ 800MHz CPU, 128MBs of ram and a 2.5GB
drive.
4: Compaq Proliant 6000 Server w/ Quad 200MHz CPUs, 128MBs of ram and a 4.3GB
SCSI drive.
All run Gentoo Linux, all run folding. #1 is my desktop, 2, 3, and 4 are set up as servers.
--
[email protected] mailing list
