Bo Andresen <bo.andresen <at> gmail.com> writes:
>
> I have a laptop with a ATI Radeon 9000 Mobility graphics card. I wanted to
> get
> 3d rendering working with the free dri drivers so I followed this howto:
> http://www.gentoolinux.org/doc/en/dri-howto.xml
Extremely cool! I tried some time ago, and gave up. If you are successful, drop
me a line, with your final list of tricks that works:
Here's my system:
from lshw:
*-display
description: VGA compatible controller
product: Radeon R250 Lf [FireGL 9000]
vendor: ATI Technologies Inc
physical id: 0
bus info: [EMAIL PROTECTED]:00.0
version: 01
size: 128MB
width: 32 bits
clock: 66MHz
capabilities: vga bus_master cap_list
configuration: driver=radeonfb
resources: iomemory:f0000000-f7ffffff ioport:9000-90ff iomemory:
ec100000-ec10ffff irq:11
>From lspci:
01:00.0 VGA compatible controller: ATI Technologies Inc Radeon R250 Lf [FireGL
9000] (rev 01) (prog-if 00 [VGA])
Subsystem: CLEVO/KAPOK Computer Unknown device 0402
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B+
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 66 (2000ns min), Cache Line Size 04
Interrupt: pin A routed to IRQ 11
Region 0: Memory at f0000000 (32-bit, prefetchable) [size=128M]
Region 1: I/O ports at 9000 [size=256]
Region 2: Memory at ec100000 (32-bit, non-prefetchable) [size=64K]
[virtual] Expansion ROM at ec120000 [disabled] [size=128K]
Capabilities: [58] AGP version 2.0
Status: RQ=48 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans-
64bit- FW+ AGP3- Rate=x1,x2,x4
Command: RQ=1 ArqSz=0 Cal=0 SBA+ AGP- GART64- 64bit- FW-
Rate=<none>
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
James
--
[email protected] mailing list
