On Tuesday 28 November 2006 04:16, Richard Fish wrote:
> On 11/27/06, Mrugesh Karnik <[EMAIL PROTECTED]> wrote:
> > > # ethernet devices
> > > ACTION=="add", SUBSYSTEM=="net", SYSFS{address}=="00:13:d3:60:4a:a5",
> > > NAME="eth0"
> > > ACTION=="add", SUBSYSTEM=="net", SYSFS{address}=="00:0d:88:45:c1:c9",
> > > NAME="eth1"
> >
> > No go. They didn't swap.
>
> Just in case, you did make those 2, not 4, lines right? Silly gmail
> word-wrapping... :-(
>
> What do "udevtest /class/net/eth0" and "udevtest /class/net/eth1"
> report? Also "udevinfo -a -p /class/net/eth0" and "udevinfo -a -p
> /class/net/eth1".
Aaah! Feels so good to be writing this email in kmail again!! So, as you might
guess, its working now.
The problem apparently was that I used upper case letters in the hex numbers.
I didn't know those hex numbers are lower case only :s
Oh and I HAD put them on two lines.
Anyway, now I get this message during bootup:
udevd-event[3110]: rename_netif: error changing net interface name eth0_rename
to eth1: No such device.
It works fine though. But, how do I get rid of that message? Its just annoying
to look at :/
/me thinks about setting RC_DEVICE_TARBALL="yes"
Anyway, all you people, thanks for your help. Very much appreciated!
--
----------------------------------------
Mrugesh Karnik
GPG Key 0xBA6F1DA8
Public key on http://wwwkeys.pgp.net
----------------------------------------
--
[email protected] mailing list
