Hi all!
I have two servers here with two Intel E1000 NIC each.
I'm planing on using the eth1 ethernet with DRBD. My problem is that
although the NICs support gigabit ethernet, they only negociate with
100baseT/Full. I'm using a CAT-5E crossover cable between the servers.
Here is my dmesg (both servers):
e1000: eth1: e1000_probe: Intel(R) PRO/1000 Network Connection
e1000: eth1: e1000_watchdog: NIC Link is Up 100 Mbps Full Duplex
My ethtool shows the following (both servers):
Settings for eth1:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: umbg
Wake-on: g
Current message level: 0x00000007 (7)
Link detected: yes
Does anyone have any tip?
Best regards,
Daniel Colchete
--
[email protected] mailing list
