On Tue, 3 Jul 2007 18:57:49 -0700 (PDT) maxim wexler <[EMAIL PROTECTED]> wrote:
> Hi group, > > I can't mount a usb music stick with a fat fs because > a drive letter eg /dev/sda has not been assigned. > Here's dmesg: > > <snip> > usb 1-2: new full speed USB device using uhci_hcd and > address 2 > usb 1-2: configuration #1 chosen from 1 choice > Initializing USB Mass Storage driver... > scsi0 : SCSI emulation for USB Mass Storage devices > usb-storage: device found at 2 > usb-storage: waiting for device to settle before > scanning > usbcore: registered new interface driver usb-storage > USB Mass Storage support registered. > scsi 0:0:0:0: Direct-Access USB FLASH DISK > V2.0 2120 PQ: 0 ANSI: 2 > usb-storage: device scan complete > usbcore: registered new interface driver usbhid > drivers/usb/input/hid-core.c: v2.6:USB HID core driver > usb 1-2: USB disconnect, address 2 > usb 1-2: new full speed USB device using uhci_hcd and > address 3 > usb 1-2: configuration #1 chosen from 1 choice > scsi1 : SCSI emulation for USB Mass Storage devices > usb-storage: device found at 3 > usb-storage: waiting for device to settle before > scanning > scsi 1:0:0:0: Direct-Access USB FLASH DISK > V2.0 2120 PQ: 0 ANSI: 2 > usb-storage: device scan complete > > And $cat /proc/partitions only lists the two > hard-drives. > > The device works OK in another gentoo unit with the > same kernel config and modules as far as usb is > concerned. > > I did #mknod /dev/sda b 8 0 and tried to mount it > there and then tried /dev/sda1 but got "/dev/sda not a > valid block device" and "/dev/sda1 does not exist" > respectively. > > Yes, the fat and vfat modules are inserted. > > Maxim Did you include modules for scsi disks? I think it's sd_mod. -- [EMAIL PROTECTED] mailing list
