>Did you autoload the module at boot (see /etc/conf.d/modules: >modules="ath_pci")? I don't write the profile, because the module can be loaded automatically at boot. I used TKIP in my D-Link Router, so I emerged wpa_supplicant yesterday, it works fine. But at Linksys WRT54G which use shared WEP, still cannot obtain the IP at boot, then I switch the encryption of WRT54G to TKIP, it got the address... Now I think there may be some issue at the WEP connection initial stage, so at last, this card works fine for me. Thank you very much.
-----邮件原件----- 发件人: Dirk Heinrichs [mailto:[EMAIL PROTECTED] 发送时间: 2008年6月27日 1:56 收件人: [email protected] 主题: Re: [gentoo-user] 答复: [gentoo-user] Atheros 5xxx driver in kernel 2. 6.24-gentoo-r5 Am Donnerstag, 26. Juni 2008 schrieb Zhou Rui: > Finally, I emerged madwifi-ng and the WLAN card works. Add if I do the > cmd > manually: > # /etc/init.d/net.ath0 start > the interface can get IP address from dhcp normally. But when I add > the net. ath0 to the runlevel default and reboot, it cannot obtain the > IP information with dhcpcd... That means I have to run the network > restart script every time the system boots... Can you give me some > advices about this? > # cat /etc/conf.d/net > > # This blank configuration will automatically use DHCP for any net.* # > scripts in /etc/init.d. To create a more complete configuration, # > please review /etc/conf.d/net.example and save your configuration # in > /etc/conf.d/net (this file :]!). > > # config_eth0=( "dhcp" ) > # dhcp_eth0="nonis nontp" > > modules=( "iwconfig" ) > key_xxxxxx="[1] cccc-cccc-cccc-cccc-cccc-cccc-cc key [1] enc restricted" > preferred_aps=( "xxxxxx" ) Hmm, isn't that WEP only (not sure)? > config_ath0=( "dhcp" ) > dhcp_ath0="nonis nontp" Here's mine: modules=( "wpa_supplicant" "dhcpcd" ) wpa_supplicant_ath0="-Dmadwifi" wpa_timeout_ath0=60 essid_ath0="<my_network_name>" config_<my_network_name>=( "dhcp" ) key_<my_network_name>="s:<my_wpa_key>" And finally, my wpa_supplicant.conf: ctrl_interface=/var/run/wpa_supplicant ctrl_interface_group=0 eapol_version=1 # ap_scan=2 was the one for me you may try 0 or 1 indstead of 2 ap_scan=0 fast_reauth=1 network={ ssid="<my_network_name>" proto=WPA key_mgmt=WPA-PSK pairwise=TKIP group=TKIP psk="<my_wpa_key>" } Of course, you need to emerge wpa_supplicant. HTH... Dirk -- [email protected] mailing list
