On Jan 31, 2009, at 7:41 PM, Arnau Bria <ar...@emergetux.net> wrote:
Hi,
I've installed wicd and configured as
http://wicd.sourceforge.net/moinmoin/Wicd on Fedora says.
*Just starting its daemon
But when I open it I only see my wired conection.
My wireless interface is avaliable via ifconfig:
# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan1 IEEE 802.11abgn ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-
Associated
Tx-Power=0 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
# ifconfig wlan1
wlan1 Link encap:Ethernet HWaddr 00:1F:3B:2A:6D:0F
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
But it does not appear in wicd client.
I'd like to use WEP keys, and I see no refernce to that option in
prefernces tab... only WPA.
Anyone with experience on wicd could give me some help, plesae?
TIA,
Arnau
Just click the tab next to each BSSID, and check "enable encryption".
Then, click the tab on what type of encryption, select WEP(hex), as
ASCII support is a bit limited. Enter in the relevent information and
join the network.
