https://www.sciencedirect.com/science/article/pii/S0169809526003741?via%3Dihub

*Authors: *Edmund Reardon, Adam Boies, Jake Chapman, Daniel Harrison, Dante
McGrath, Hugh Hunt, Shaun Fitzgerald

*25 May 2026*

10.1016/j.atmosres.2026.109110

*Highlights*
•Majority (99.5%) of droplets from superheated atomisation of seawater are
submicron.

•Potential improvement in marine cloud brightening sprayers with
superheated spray.

•Effects of temperature and pressure on submicron particle size
distributions.

•Increasing temperature narrows submicron particle size distributions.

•Reducing pressure or flow rate increases volume fraction of submicron
particles.

*Abstract*
Marine cloud brightening (MCB) is a proposed regional or global cooling
technique that aims to increase cloud albedo by increasing the number of
cloud condensation nuclei in low-lying marine clouds. Spraying micron or
submicron droplets of seawater at a sufficient rate is considered the most
suitable method for generating salt crystals for this purpose.
The technique of effervescent spraying has been used in outdoor MCB field
trials. This study explores superheated atomisation as an alternative
technology.

The performance of a continuous steady-state superheated saline solution
sprayer has been characterised across a wide range of operating parameters
and the effects of temperature, pressure, and nozzle expansion chamber
length on production rate and generated particle sizes have been
quantified. Results show that the technology can achieve a monomodal
aerosol size distribution of dry salt particles with a mode of 65-75 nm and
a geometric standard deviation of 1.85 when using a converging nozzle with
a 200 μm diameter orifice. By number, 99.5% of droplets generated are
submicron and 87% are within a size range suitable for MCB. The superheated
atomiser developed and tested in this study is found to have comparable
energy requirements to effervescent technology but with narrower size
distributions, a likely benefit for MCB. However, at optimum sprayer
performance the measured production of submicron dry crystals accounted for
14% of the saline solution mass flow, approximately 3.2 times less than for
effervescent spray. This indicates that 86% of the mass was contained in
larger particles.
This study demonstrates that superheated atomisation could be a viable
method for generation of salt aerosol for MCB, depending on the negative
effects of the large particles or the ability to remove them through
further system optimisation.

*Source: ScienceDirect *

-- 
You received this message because you are subscribed to the Google Groups 
"geoengineering" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To view this discussion visit 
https://groups.google.com/d/msgid/geoengineering/CAHJsh988L6VWba8VFbTW380pK860TYfoORGk%3DkqvOSJXRsoLGw%40mail.gmail.com.

Reply via email to