You can use excel. ..go to the project folder using excel>spc file>delimited>use cyc/k and Ln_p as your X and Y.....then use matlap to calculate depth 1 and depth 2. Hope this will help you. Solomon Nehemiah Yusuf PhD student On 28 Jan 2015 20:33, "ghataas <[email protected]>" < [email protected]> wrote:
> Hi everybody > How can I calculate the depth from the power spectrum curve > or redraw the curve in another format that could be easier to the people, > for instant in terms of depth range or intervals > Appreciation > > > > > > -- > *Akram Mekhael* > ============================ > *Akram Mekhael Aziz > د. أكرم ميخائيل عزيز * > *Dept. of Geology, Faculty of Science > قسم الجيولوجيا بكلية العلوم* > *Port Said University > جامعة بورسعيد * > *23 December Street, Room 1/10 > **بورسعيد > **- مصر * > *Port Said 42522, **Egypt* > *Port Said, Egypt * > > > Cell phone: +2 01221285530 > E-mail: [email protected] > [email protected] > [email protected] > > > > --- > > Forum archives can be accessed here: > http://lyris.geosoft.com/read/?forum=geonet > <http://lyris.geosoft.com/read/?fourm=geonet> > > You are currently subscribed to geonet as: [email protected]. > > To subscribe or unsubscribe from any of our forums, select the User Forum > selection on the Geosoft Community page: > http://www.geosoft.com/support/community/forums/register/ > --- Forum archives can be accessed here: http://lyris.geosoft.com/read/?forum=geonet You are currently subscribed to geonet as: [email protected]. To subscribe or unsubscribe from any of our forums, select the User Forum selection on the Geosoft Community page: http://www.geosoft.com/support/community/forums/register/
