It changed but not to the correct bounding box.
-------- Original message --------
From: Russell Hore
Date:05/07/2014 3:04 AM (GMT-05:00)
To: Jonatan Malaver
Cc: [email protected]
Subject: Re: [Geoserver-users] bounding box
Go to the layer in the Administration interface.
"Under Bounding Box” click on ‘Compute from Data’ (and ‘Compute from native
bounds’ ?). See if the coords change.
Save the layer
Russ
On 6 May 2014, at 19:26, Jonatan Malaver
<[email protected]<mailto:[email protected]>> wrote:
Hello,
I have a PostGIS store in Geoserver 2.4, where the computed native bounding
box x,y and lat/long are incorrect. When I try to preview the layer, the layer
is cut on the map. Could anyone help me resolve this problem? The postgis table
was recently updated (more geometry added). I’m having problems with the new
geometry added to the table. I have tried deleting the layer and adding it
again and problem persists.
Thanks,
Jon
------------------------------------------------------------------------------
Is your legacy SCM system holding you back? Join Perforce May 7 to find out:
• 3 signs your SCM is hindering your productivity
• Requirements for releasing software faster
• Expert tips and advice for migrating your SCM now
http://p.sf.net/sfu/perforce_______________________________________________
Geoserver-users mailing list
[email protected]<mailto:[email protected]>
https://lists.sourceforge.net/lists/listinfo/geoserver-users
------------------------------------------------------------------------------
Is your legacy SCM system holding you back? Join Perforce May 7 to find out:
• 3 signs your SCM is hindering your productivity
• Requirements for releasing software faster
• Expert tips and advice for migrating your SCM now
http://p.sf.net/sfu/perforce
_______________________________________________
Geoserver-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/geoserver-users
