Op 07-09-2021 om 16:30 schreef Broking, Brian R:
I am trying to get Geoserver running on a Stand Alone/Air gapped machine
(no internet access) and hoping I can be provided some pointers.
I have a Virtual Machine with Internet access and have confirmed on RHEL
8 GeoServer Binary will run just fine. But as soon as I put it on a
Stand Alone machine it starts but I get a 504 error just trying to get
to http://localhost:8080/geoserver <http://localhost:8080/geoserver>.
I have tried looking through the start.ini, the xml files, everywhere I
can think off. But I am missing something. The error basically says
jetty has not started. And I have tried to unzip start.jar to see what
might be in there. However, I just can not find what is requiring the
Internet or the answer from the internet to actually start. If someone
could point me in the direction to strip out the Internet requirement I
would appreciate it.
does networking work at all? if the machine is disconnected it might
drop (part of) tcp/ip networking and jetty would fail to bind to
0.0.0.0:8080. perhaps you can get jetty to bind to a loopback address
only like 127.0.0.1:8080.
Note I could be way off; it's been a long time since I've seen
disconnected machines.
also using eg. curl with high verbosity may give better diagnostic info
than a browser
-M
_______________________________________________
Geoserver-users mailing list
Please make sure you read the following two resources before posting to this
list:
- Earning your support instead of buying it, but Ian Turton:
http://www.ianturton.com/talks/foss4g.html#/
- The GeoServer user list posting guidelines:
http://geoserver.org/comm/userlist-guidelines.html
If you want to request a feature or an improvement, also see this:
https://github.com/geoserver/geoserver/wiki/Successfully-requesting-and-integrating-new-features-and-improvements-in-GeoServer
Geoserver-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/geoserver-users
