Ciao Martin,
thanks for the insight. Tomorrow, I will be spending some time with
daniele and alessio to discuss about where we are and where we are
going.
I'll try to report some thoughts afterwards, porbably using gt wiki.

Simone.

On Thu, Jul 3, 2008 at 12:37 PM, Martin Desruisseaux
<[EMAIL PROTECTED]> wrote:
> Hello Simone
>
> Simone Giannecchini a écrit :
>>
>> Can you elaborate a bit on this? What are you planning to do, but more
>> important when?
>
> I don't know yet, because I have not yet looked closely enough to the new
> temporal package. I'm assuming that when I will do so, I may find redundancy
> with current TemporalCRS implementation which will need to be resolved.
>
> However I don't think there is any action needed right now. The conversion
> performed in current TemporalCRS implementation is quite simple (just a very
> few lines) and so straightforward that disprencies with an other package
> seems unlikely to me. If we were leveraging the new temporal package right
> now, it would means promoting it to the referencing module (or making the
> referencing module dependant on the temporal package), which seems a little
> bit premature to me.
>
>        Martin
>



-- 
-------------------------------------------------------
Eng. Simone Giannecchini
President /CEO GeoSolutions S.A.S.
Via Carignoni 51
55041 Camaiore (LU)
Italy

phone: +39 0584983027
fax: +39 0584983027
mob: +39 333 8128928


http://www.geo-solutions.it

-------------------------------------------------------

-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
Geotools-devel mailing list
Geotools-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/geotools-devel

Reply via email to