Thanks Ian! BTW can you give and advice about some good reference (book or other resource) on map projections and cartography?
Thanks once again, Sergey On 9/2/2010 9:23 PM, Ian Turton wrote: > On Thu, Sep 2, 2010 at 6:33 AM, LSA<[email protected]> wrote: > >> Hi everyone! >> > >> So, one can notice that every point of my polygon is projected to single >> (500000.00000000064, 9997964.943021908, NaN). >> > I don't think you can do that - looking at > http://www.spatialreference.org/ref/epsg/32632/ and > http://www.spatialreference.org/ref/epsg/32617/ you can see that there > the two zones are not even close to each other. Any point in one zone > will be out side the defined area of the other one so I'd expect the > transformation to fail - others with more experience of the GeoTools > code than I have may be able to say why you get any answer as opposed > to say an InvalidArgument Exception. > > Basically this comes down to the earth being round and the screen being flat. > > Ian > > ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Geotools-gt2-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/geotools-gt2-users
