Neels Hofmeyr has submitted this change and it was merged. ( https://gerrit.osmocom.org/11535 )
Change subject: bsc: handover: mention the need to resend SI for telnet neighbor cfg ...................................................................... bsc: handover: mention the need to resend SI for telnet neighbor cfg Change-Id: I305ef558b75697015e2532aa7c135f7995662e0d --- M OsmoBSC/chapters/handover.adoc 1 file changed, 9 insertions(+), 0 deletions(-) Approvals: Harald Welte: Looks good to me, approved diff --git a/OsmoBSC/chapters/handover.adoc b/OsmoBSC/chapters/handover.adoc index b763701..297eafc 100644 --- a/OsmoBSC/chapters/handover.adoc +++ b/OsmoBSC/chapters/handover.adoc @@ -307,6 +307,15 @@ the MSC, the configured cell identifiers must be of the same type. If in doubt, use the full CGI identifier everywhere. +==== Reconfiguring Neighbors in a Running OsmoBSC + +When modifying a cell's neighbor configuration in a telnet VTY session while a cell is already active, +the neighbor configuration will merely be cached in the BSC's local config. To take actual effect, it is +necessary to + +- either, re-connect the cell to the BSC (e.g. via `drop bts connection <0-255> oml`) +- or, re-send the System Information using `bts <0-255> resend-system-information`. + === Configuring Handover Decisions For a long time, OsmoBSC has supported handover based on reception level -- To view, visit https://gerrit.osmocom.org/11535 To unsubscribe, or for help writing mail filters, visit https://gerrit.osmocom.org/settings Gerrit-Project: osmo-gsm-manuals Gerrit-Branch: master Gerrit-MessageType: merged Gerrit-Change-Id: I305ef558b75697015e2532aa7c135f7995662e0d Gerrit-Change-Number: 11535 Gerrit-PatchSet: 2 Gerrit-Owner: Neels Hofmeyr <[email protected]> Gerrit-Reviewer: Harald Welte <[email protected]> Gerrit-Reviewer: Jenkins Builder (1000002)
