Hello Harald Welte, Jenkins Builder,
I'd like you to reexamine a change. Please visit
https://gerrit.osmocom.org/12884
to look at the new patch set (#2).
Change subject: firmware/board/compal: indicate both DCS and PCS Rx ports as
connected
......................................................................
firmware/board/compal: indicate both DCS and PCS Rx ports as connected
Each given Mot C1xx phone is made either for 900+1800 MHz, in which
case only the DCS Rx port is connected, or for 850+1900 MHz, in which
case only the PCS Rx port is connected. Let's tell the TRF6151 driver
that both DCS and PCS ports are connected, so that the same binary
build can be used on both EU-band and US-band C1xx phones.
If one needs to tune the TRF6151 receiver out of spec, or at least
outside of the DCS/PCS Rx SAW filter's legitimate passband (or if
the SAW filter was changed or removed), then the rffe_get_rx_ports()
function might be changed to indicate which Rx port is physically
connected: PORT_DCS1800 only or PORT_PCS1900 only.
Change-Id: I620084c33ad165faffbbfc45923faedad77aafb2
---
M src/target/firmware/board/compal/rffe_dualband.c
M src/target/firmware/board/compal_e86/rffe_dualband_e86.c
2 files changed, 44 insertions(+), 4 deletions(-)
git pull ssh://gerrit.osmocom.org:29418/osmocom-bb refs/changes/84/12884/2
--
To view, visit https://gerrit.osmocom.org/12884
To unsubscribe, or for help writing mail filters, visit
https://gerrit.osmocom.org/settings
Gerrit-Project: osmocom-bb
Gerrit-Branch: master
Gerrit-MessageType: newpatchset
Gerrit-Change-Id: I620084c33ad165faffbbfc45923faedad77aafb2
Gerrit-Change-Number: 12884
Gerrit-PatchSet: 2
Gerrit-Owner: Vadim Yanitskiy <[email protected]>
Gerrit-Reviewer: Harald Welte <[email protected]>
Gerrit-Reviewer: Jenkins Builder (1000002)
