On Jan 27, 2007, at 12:44 PM, Barry Bickmore wrote:
Hi everyone,
I am running RB 2006 Release 3 on a new MacBook, and I have never
done remote debugging before, since I only recently upgraded to the
Professional edition. Anyway, now I have Parallels running on my
MacBook, which allows me to run virtual Windows XP and Ubuntu Linux
machines. I have set up the remote debugger stubs on the Mac and
the Windows VM, and I opened the proper ports on the Windows
firewall. I couldn't figure out how to make sure the right ports
are open on the Mac, so I just temporarily shut off the firewall.
I have both the Mac and Windows VM environments running, and the
remote debugging stub is running on Windows. I open a project in
the IDE on the Mac, and set up the remote debugging--it seems to
recognize the Windows VM just fine. However, when I try to
remotely debug the project, it compiles for Windows, says it is
transferring the file to the Windows VM, but as soon as the
transfer starts, the remote debugger stub on the Windows VM says it
has an "OutofBoundsException", or something like that, and says it
has to shut down. So then the transfer is stalled, and if I try to
stop the debugging process, the RealBasic IDE freezes.
Any ideas about what might be going wrong?
What did you use for your network setup for Parallels ?
I've used it in precisely the way you describe without an issue but
I've set my networking in my Parallels VM to Bridged Ethernet,
Enabled, Connect cable at startup
_______________________________________________
Unsubscribe or switch delivery mode:
<http://www.realsoftware.com/support/listmanager/>
Search the archives of this list here:
<http://support.realsoftware.com/listarchives/lists.html>
