Just removing UML_# directories should be sufficient for this one.

The others can be removed as well. There is hardly any state maintained
across

other elements .. so it does not matter.

 

From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Imad
Gharazeddine | McGill
Sent: November-16-08 11:53 PM
To: Muthucumaru Maheswaran
Cc: Alexis Malozemoff
Subject: Re: New version of GINI

 

Ok this worked. Is it safe to remove the entire 'data' directory which
contains the UML_# directories?? Or should we keep it?

-- Imad



On Sun, Nov 16, 2008 at 11:48 PM, Muthucumaru Maheswaran
<[EMAIL PROTECTED]> wrote:

Are you using any old UMLs? 

Please remove the old .cow files. You can do this by removing the UML_#
directories

under data/ directory. 

If you are keeping any configurations from old UMLs.. then it might be a
concern. I

was assuming that is not the case.

 

 

From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Imad
Gharazeddine | McGill
Sent: November-16-08 11:45 PM
To: Muthucumaru Maheswaran
Cc: Alexis Malozemoff
Subject: Re: New version of GINI

 

Hi Professor,

We just downloaded and installed GINI 1.06 and there seems to be segfaults
occuring as soon as any network topology is started. These segfaults are in
the UMLs.

Our simple network was 2 UMLs connected to 1 switch, which was connected to
a subnet with IP 192.168.1.0/24

Please advise as soon as possible, as we cannot continue working until this
is fixed.

Thanks,

-- Imad

On Sun, Nov 16, 2008 at 9:11 PM, Muthucumaru Maheswaran
<[EMAIL PROTECTED]> wrote:

I have posted version 1.06 of GINI on the website. It fixes a

gbuilder bug in IP address assignment in topologies with 

multiple routers. Also, the UMLs should show the current IP

address and working directory on the command prompt.

 

 

 

_______________________________________________
gini mailing list
gini@cs.mcgill.ca
http://mailman.cs.mcgill.ca/mailman/listinfo/gini

Reply via email to