gene-bordegaray commented on code in PR #22607: URL: https://github.com/apache/datafusion/pull/22607#discussion_r3323734866
########## datafusion/sqllogictest/test_files/range_partitioning.slt: ########## @@ -0,0 +1,81 @@ +# Licensed to the Apache Software Foundation (ASF) under one +# or more contributor license agreements. See the NOTICE file +# distributed with this work for additional information +# regarding copyright ownership. The ASF licenses this file +# to you under the Apache License, Version 2.0 (the +# "License"); you may not use this file except in compliance +# with the License. You may obtain a copy of the License at +# +# http://www.apache.org/licenses/LICENSE-2.0 +# +# Unless required by applicable law or agreed to in writing, +# software distributed under the License is distributed on an +# "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY +# KIND, either express or implied. See the License for the +# specific language governing permissions and limitations +# under the License. + +# The sqllogictest harness registers range_partitioned(range_key, non_range_key, value) +# as an in-memory source with four physical source partitions: +# +# partition 0: range_key in [1, 10), rows (1, 1, 10), (5, 2, 50) +# partition 1: range_key in [10, 20), rows (10, 1, 100), (15, 2, 150) +# partition 2: range_key in [20, 30), rows (20, 1, 200), (25, 2, 250) +# partition 3: range_key in [30, ...), rows (30, 1, 300), (35, 2, 350) + +statement ok +set datafusion.explain.physical_plan_only = true; + Review Comment: Ya I omitted these for cimplicity but I actually think you are correct and these will be fitting to se change as more logic is added -- This is an automated message from the Apache Git Service. To respond to the message, please log on to GitHub and use the URL above to go to the specific comment. To unsubscribe, e-mail: [email protected] For queries about this service, please contact Infrastructure at: [email protected] --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
