----- Original Message -----
> From: "A Ghoshal" <[email protected]>
> To: [email protected]
> Sent: Tuesday, February 3, 2015 12:00:15 AM
> Subject: [Gluster-users] A few queries on self-healing and AFR (glusterfs
> 3.4.2)
> Hello,
> I have a replica-2 volume in which I store a large number of files that are
> updated frequently (critical log files, etc). My files are generally stable,
> but one thing that does worry me from time to time is that files show up on
> one of the bricks in the output of gluster v <volname> heal info. These
> entries disappear on their own after a while (I am guessing when
> cluster.heal-timeout expires and another heal by the self-heal daemon is
> triggered). For certain files, this could be a bit of a bother - in terms of
> fault tolerance...
In 3.4.x, even files that are currently undergoing modification will be listed
in heal-info output. So this could be the reason why the file(s) disappear from
the output after a while, in which case reducing cluster.heal-timeout might not
solve the problem. Since 3.5.1, heal-info _only_ reports those files which are
truly undergoing heal.
> I was wondering if there is a way I could force AFR to return
> write-completion to the application only _after_ the data is written to both
> replicas successfully (kind of, like, atomic writes) - even if it were at
> the cost of performance. This way I could ensure that my bricks shall always
> be in sync.
AFR has always returned write-completion status to the application only _after_
the data is written to all replicas. The appearance of files under modification
in heal-info output might have led you to think the changes have not (yet) been
synced to the other replica(s).
> The other thing I could possibly do is reduce my cluster.heal-timeout (it is
> 600 currently). Is it a bad idea to set it to something as small as say, 60
> seconds for volumes where redundancy is a prime concern?
> One question, though - is heal through self-heal daemon accomplished using
> separate threads for each replicated volume, or is it a single thread for
> every volume? The reason I ask is I have a large number of replicated
> file-systems on each volume (17, to be precise) but I do have a reasonably
> powerful multicore processor array and large RAM and top indicates the load
> on the system resources is quite moderate.
There is an infra piece called syncop in gluster using which multiple heal jobs
are handled by handful of threads. The maximum it can scale up to is 16
depending on the load. It is safe to assume that there will be one healer
thread per replica set. But if the load is not too high, just 1 thread may do
all the healing.
-Krutika
> Thanks,
> Anirban
> =====-----=====-----=====
> Notice: The information contained in this e-mail
> message and/or attachments to it may contain
> confidential or privileged information. If you are
> not the intended recipient, any dissemination, use,
> review, distribution, printing or copying of the
> information contained in this e-mail message
> and/or attachments to it are strictly prohibited. If
> you have received this communication in error,
> please notify us by reply e-mail or telephone and
> immediately and permanently delete the message
> and any attachments. Thank you
> _______________________________________________
> Gluster-users mailing list
> [email protected]
> http://www.gluster.org/mailman/listinfo/gluster-users
_______________________________________________
Gluster-users mailing list
[email protected]
http://www.gluster.org/mailman/listinfo/gluster-users
