----- Original Message ----- > From: "marianna cattani" <[email protected]> > To: [email protected] > Sent: Monday, March 23, 2015 6:09:41 AM > Subject: [Gluster-users] What should I do to improve performance ? > > Dear all, > I followed the tutorial I read at this link : > http://www.gluster.org/documentation/use_cases/Virt-store-usecase/ > > I have 4 nodes configured as a linked list , each node also performs virtual > machines with KVM and mounts on its ip address, like this: > > 172.16.155.12:/nova /var/lib/nova/instances glusterfs defaults,_netdev 0 0 > > Each node has two nic (ten giga) bonded in mode 4. > > What can I do to further improve the speed ?
What kind of disks are back ending your 10G NICs? Are you using FUSE or libgfapi to connect to gluster from your hypervisor? What kind of speeds are you expecting vs seeing in your environment? We need to understand what your HW can do first then gather some data running on gluster and compare the two. As a rule of thumb with replica 2 you should see about: throughput = ( NIC line speed / 2 ) - 20% overhead As long as your disks can service it. If you are seeing about that on the gluster mounts then go inside one of the VMs and run the same test, the VM should get something similar. If you aren't seeing at least 400 MB / sec on sequential writes and 500-700 MB /sec on reads then there may be something off in your storage stack. -b > BR. > > M. > > _______________________________________________ > Gluster-users mailing list > [email protected] > http://www.gluster.org/mailman/listinfo/gluster-users _______________________________________________ Gluster-users mailing list [email protected] http://www.gluster.org/mailman/listinfo/gluster-users
