I was wrong, it crashes also for cl=0.0005 (but after a looong time, and
with a runtime error).
________________________________
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of Zenker, Dr. Matthias
Sent: Monday, November 17, 2008 10:16 AM
To: [email protected]
Subject: [Gmsh] lower limit for characteristic length
Hi,
I wonder if there is a lower limit for the characteristic
length. I have a rather simple 2D geometry, and if I set the cl for just
two points to 0.0001, gmsh crashes during the meshing after having given
the error message "3 identical points in Qtest". The .gmsh-errors file
is not written. With cl=0.0005, this does not happen (but it takes
veeery long to compute the mesh).
Best regards,
Matthias
----------------------------------------------------------------
ERBE Elektromedizin GmbH
Dr.rer.nat. Matthias Zenker
Dipl. Phys.
Grundlagenentwicklung Technologie
Waldhoernlestrasse 17
D-72072 Tuebingen
Tel.: + 49 (0) 7071 - 755 226
Fax: + 49 (0) 7071 - 755 5226
E-Mail: <mailto:[EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]> >
URL: http://www.ERBE-med.de <http://www.ERBE-med.de>
----------------------------------------------------------------
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137
_____________________________________________________________________
ERBE Elektromedizin GmbH
Firmensitz: 72072 Tuebingen
Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede
Registergericht: Stuttgart HRB 380137
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
