Dear All,
I generate a set of surfaces (patches) which together define a closed shell and
then use a surface loop to define the closed shell.
Meshing this setup creates a separate mesh for each surface (patch). How can I
make Gmsh:
a) `glue' all these `patches' together and treat them as a single surface?
b) following a), create a single mesh covering the entire closed shell?.
Currently, since Gmsh treats each patch seperately and does not `see' the full
shell if I want to refine the mesh I must set the element size to be smaller
then the sides of the patches, but it should relate to the sides of the entire
shell.
Cheers and thanks,
Mike.
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
