Hello,
I would like to know if it is possible to do a size function in Gmsh.
Furthermore, how can I use this command :Mesh.CharacteristicLengthFromPoints?
Med vanlig hälsning / Best regards
■ STEPHANE BLANCHET // TRAINEE CFD ENGINEER, AIR SYSTEMS & THERMAL MANAGEMENT - MICROWAVE GPB
Office +46 11 15 40 00 // Fax +46 11 15 40 01 // Whirlpool Corporation // www.WhirlpoolCorp.com
[email protected] // Whirlpool Sweden AB, Box 763, SE-601 17 Norrkoping, Sweden
This message may contain confidential and/or privileged information. If you are not the addressee, you may not use, copy or disclose this message. If you received this message in error, please delete it and advise sender listed above.
Please consider the environment before printing this e-mail
■ STEPHANE BLANCHET // TRAINEE CFD ENGINEER, AIR SYSTEMS & THERMAL MANAGEMENT - MICROWAVE GPB
Office +46 11 15 40 00 // Fax +46 11 15 40 01 // Whirlpool Corporation // www.WhirlpoolCorp.com
[email protected] // Whirlpool Sweden AB, Box 763, SE-601 17 Norrkoping, Sweden
This message may contain confidential and/or privileged information. If you are not the addressee, you may not use, copy or disclose this message. If you received this message in error, please delete it and advise sender listed above.
Please consider the environment before printing this e-mail
_______________________________________________ gmsh mailing list [email protected] http://www.geuz.org/mailman/listinfo/gmsh
