On 17/06/10 17:37, Martin Vymazal wrote:
Hello,
I would like to ask if it is possible to launch the 'reclassify' command
from command line. I normally use it from the gui, but since all the
other mesh processing is done using scripts, it would be nice if I could
do this also without opening the gui.
I have one more little question. Suppose I run reclassify, I get a lot
of surfaces and I hide some of them by clicking in the gui. Is it
possible to create a new geo/msh file which contains only entities
currently set as visible? What I mean is that I don't want to save a
file which is the original mesh with additional info about visibility,
but I'd like to have a new file in which the 'invisible' parts are
completely absent.
Hi Martin - No, but these would be two nice additions. Could file
requests for enhancement in the bug tracking system? This will help us
keep track of the ideas.
Thank you.
Best regards,
Martin Vymazal
----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
--
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://www.montefiore.ulg.ac.be/~geuzaine
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
