Hi Julien, thanks for your help, you are right. Now all works!
Best regards, Patrick On 06/05/2011 11:42 AM, julien hoessler wrote:
Hi Patrick, You get a lot of errors when meshing your test02. Could it be because you are using a single BSpline? The surface of revolution would be a curved surface based on only two edges when 3 at least are needed if I'm not mistaken. Attached is a modified version of your test02 with the BSpline split into two that works fine Regards Julien
_______________________________________________ gmsh mailing list [email protected] http://www.geuz.org/mailman/listinfo/gmsh
