Re: [Gmsh] Creating a cylinder with a hole

Ruth V. Sabariego Thu, 09 Feb 2012 12:29:27 -0800

The arcs should be smaller than Pi, otherwise there is a problem with indetermination.

Have a look at the corrected attached file.

Regards,

Ruth

nnn.geo
Description: Binary data

Dr. Ir. Ruth V. Sabariego

University of Liege, Electrical Engineering & Computer Science,

Applied & Computational Electromagnetics (ACE),

phone: +32-4-3663737 - fax: +32-4-3662910 - http://ace.montefiore.ulg.ac.be/

On 08 Feb 2012, at 17:10, Orhan Shibliyev wrote:

Hi all

I am trying to create a cylinder (with a hole) made up of two parts. Without extrusion, when it is meshed 2D, everything is OK however, when I extrude one of the surfaces, other half becomes deleted. Does not matter which half extruded first, the result is not what I want. I attached the geo file.
<nnn.geo>_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh

_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh

Re: [Gmsh] Creating a cylinder with a hole

Reply via email to