Hi everyone, I'm using gmsh to create a mesh for flow analysis and realised that the extrude command can extrude curved surfaces in the direction normal to the plane, scaling the outer face of the extrusion accordingly. This is exactly what I was looking for a few months ago when I posted, asking how to extrude with scaling.
However, now I'd like to attach more mesh to the outside of this boundary layer. However, in my versions of gmsh (2.4.2 and 2.5.1-svn, 20110525) the nodes defining the new, extruded face are not created in the geometry so I cannot use them in later definitions. Is there a switch I can use to create the nodes defining the outer face during the geometry phase? Best regards, Mark. -- Dr. Mark Starnes Principal Physicist FT Technologies Church Lane Teddington TW11 8PA web: www.fttech.co.uk DDI: 0208 614 2730 _______________________________________________ gmsh mailing list [email protected] http://www.geuz.org/mailman/listinfo/gmsh
