Hi,
For a boundary layer mesh creation, is there a way to extrude a line in wall
normal direction?
Extrude { expression-list } { extrude-list layers } requires specification of
normal, however I am looking for something in which I will be required to
specify only to extrude in inside or outside direction.
Thanks & Regards,
Suraj
The information in this e-mail is confidential. The contents may not be
disclosed or used by anyone other than the addressee. Access to this e-mail by
anyone else is unauthorised.
If you are not the intended recipient, please notify Airbus immediately and
delete this e-mail.
Airbus cannot accept any responsibility for the accuracy or completeness of
this e-mail as it has been sent over public networks. If you have any concerns
over the content of this message or its Accuracy or Integrity, please contact
Airbus immediately.
All outgoing e-mails from Airbus are checked using regularly updated virus
scanning software but you should take whatever measures you deem to be
appropriate to ensure that this message and any attachments are virus free.
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
