On 12 Feb 2014, at 14:41, Philippe Ackerer <[email protected]> wrote:
> Hi,
> Following my previous mail, I try to generate a prismatic mesh of a cylinder
> without the 'extrude' command to prescribe the identity value of the sides.
> I used Transfinite instructions without success (the 3D elements are not
> prisms - see attached file).
>
Change
Recombine Volume {301}; // highly experimental stuff ;-)
into
Transfinite Volume {301};
You'll probably want to use Extrude instead, though -- it's much easier.
> Any help is very welcomed. Thanks,
> Philippe
>
> --
> --------------------------------------------------------------
> Philippe ACKERER
> LHyGeS UMR 7517 UdS-CNRS-Engees
> 1, rue Blessig
> 67000 STRASBOURG
> tel +33 (0)368 850 561
> -------------------------------------------------------------
>
> <col3.geo>_______________________________________________
> gmsh mailing list
> [email protected]
> http://www.geuz.org/mailman/listinfo/gmsh
--
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://www.montefiore.ulg.ac.be/~geuzaine
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
